High Efficiency COB LED Strip

Product Description

If you want the dot-free look of COB but your channel or PCB slot is only 10mm wide, this is the strip I'd reach for. It fits a standard 10mm footprint, packs 512 LEDs per meter, and draws just 14W/m on 24V DC, so you get a clean continuous line without the heat and power load of wider high-density boards. CRI is above 90, with 2700K, 4000K, and 6500K in stock.

Why a 10mm, 512-LED COB

A lot of slim COB strips either run too dim to be useful or push density so high they need big drivers and heatsinking. This one sits in the middle: 512 LEDs/m is enough density that the individual points blend into one line at normal viewing distance, while 14W/m keeps it easy to power and cool. Because it stays at 10mm, it drops straight into the aluminum profiles and connectors most projects already use.

Key Features

• 512 LEDs/m on a 10mm PCB — dot-free, continuous beam
• 14W/m, 24V DC — low thermal load, long cable runs with less voltage drop
• CRI >90 for accurate color in retail and residential settings
• 2700K / 4000K / 6500K white options
• Flexible COB construction, standard 10mm connectors and profiles

Typical Applications

• Under-cabinet and shelf lighting in 10mm channels
• Cove and indirect lighting where heat needs to stay low
• Retail display and showcase lighting with high color accuracy
• Furniture, wardrobe, and OEM built-in lighting

Specifications

Installation notes

1. Mount inside an aluminum profile where possible — even at 14W/m it helps the board run cooler.
2. Use a 24V constant-voltage driver sized at least 20% above total wattage.
3. Feed power every 5m to avoid visible dimming toward the end of a run.
4. Peel the backing tape a little at a time and press firmly onto a clean, dry surface.

Frequently Asked Questions

Is 512 LEDs per meter enough to look dot-free?

At 10mm width and normal viewing distances (30cm or more behind a diffuser), yes — the points blend into a single line. For very close, bare-strip viewing you'd want a higher density board.

Can I cut it to length?

Yes, cut along the marked solder pads. Re-connect with 10mm COB connectors or solder leads directly to the pads.

Does it need a heatsink?

At 14W/m an aluminum profile is recommended for long life, though it runs cool enough for short open-air runs without one.

Can I order custom specifications or OEM branding?

Yes. As the manufacturer we support custom lengths, colour temperature, CRI, packaging and OEM labeling; send us your specification.

Can I request a sample before a bulk order?

Yes, samples are available so you can confirm the colour, build and output before a bulk order. Request a sample through our contact page.