LED Strip Lighting Blog & Buying Guides

2026-11-02

A wire bent at the hinge every day snaps after a few thousand cycles. I route a service loop, choose flexible cable and protect the hinge point.

2026-11-02

Flat VHB needs a flat face; stucco and concrete give it air pockets. I seal the surface, bridge the gaps and rely on clips for rough masonry.

2026-11-02

The paint film lets go before the tape does. I prep the surface, check the paint type, and add clips until the adhesive has a real bond.

2026-11-02

A long cove fed from one end dims toward the far corner. I size center injection, wire gauge and how many feeds a cove actually needs.

2026-11-02

Rope light ran on a mains loop; a COB shelf run wants 24V and fresh loading. I walk the swap without ripping out every existing wire.

2026-11-02

COB flexes but the copper trace has a breaking point. I locate the cracked section, cut back to a good pad, and bend only within the radius.

2026-11-02

A pink or green white points to a missing or weak die channel and sloppy binning. I show how to tell binning fault from driver and dimming fault.

2026-11-02

A closed cabinet turns a dense COB run into an oven. I measure the temperature rise, vent the cavity and derate the strip wattage.

2026-11-02

Too close and you see bright dots; too far and the glow dies. I give the stand-off range and diffusion material for an even halo panel.

2026-11-02

A warm white board behind a thin diffuser reads as a coloured shadow at night. I cover board colour, diffuser opacity and setback that hide it.

2026-11-02

Wide clip spacing lets a heavy flex hang in shallow waves. I tighten the rhythm, support corners and check the flex cross-section for the run.

2026-11-02

A panel that curves in two axes fights a single-plane flex. I pick side-bend versus top-bend flex and split the run where the curve twists.