LED Strip Lighting Blog & Buying Guides

2026-10-28

The wire exit from a channel end is where water enters. I choose grommet vs slot and seal the right one.

2026-10-28

Flexible profiles bend, but only down to a radius. I set the minimum curve and when to go segmented instead.

2026-10-28

A yellowed diffuser dims and tints the light. I show how to swap just the diffuser and keep the strip.

2026-10-28

A badly cut mitre leaves a dark V at the corner. I cut and join so the light continues seamlessly around the turn.

2026-10-28

Outdoor profile finish decides corrosion and fade. I pick anodised vs powder coat by exposure and colour.

2026-10-28

A hairline shadow along the reveal is usually the edge lip, not the plasterer. I align the lip and float it flush.

2026-10-28

A thin long wire to a distant driver dims the start of the strip. I size the gauge by run length and load.

2026-10-28

A touch pad where the kettle bumps it is annoying. I place and tune it so brushing past does not switch the light.

2026-10-28

A sensor that fires every time the curtain moves is tuned wrong. I adjust range, time-out and mounting height to stop it.

2026-10-28

Chaining drivers on one switch load trips the breaker at startup. I explain parallel input vs daisy chain and the inrush math.

2026-10-28

A push-in connector is designed once. Reusing it cuts contact pressure. I say when to swap it and how to inspect it.

2026-10-28

Connectors are the first thing to green-fuzz at the coast. I grease, seal and choose the right connector for salt air.